• The D100 is not suitable as a pure vacuum cleaner, as it sprays water in the first five seconds of dry vacuuming to protect the HEPA filter from clogging.
• To check whether water continues to be emitted after the first 5 seconds, remove the cover over the brush roller, restart the appliance, select Dry Mode and check that water is coming out of the nozzle. If water continues to escape after 5 seconds, there is a defect in the appliance. In this case, the appliance must be sent for inspection and repair.

1. Activate self-cleaning mode: Single click on the self-cleaning button/water level control.
2. Activate drying mode: Long press on the self-cleaning button /water level control

1. Please check the following:

• Check the nozzle: Check whether the nozzle sprays water.


2. Possible causes:

• No water in the fresh water tank.
• The sealing ring is missing or installed the wrong way round.
• The nozzle under the roller cover is blocked.
• The hose of the fresh water tank is loose.
• The contact of the HEPA filter has been lost.
• Water pump defective - the appliance must be sent for inspection and repair.

• Check if the charging plug is connected properly.
• Ensure the device is completely placed in the charging base.
• Check the connection between the charging head and the charging base for poor contact.

• Drain the wastewater in the wastewater tank if it is full.
• Ensure HEPA and the wastewater tank are installed properly.

The usage time of your Uwant D100 varies depending on the mode it operates in:

• Dry Mode: The battery life can last up to 35 minutes.
• Smart Mode: The battery life is approximately 24 minutes, which is normal.
• Turbo Mode: The battery life is around 20 minutes.

The advertised battery life of up to 35 minutes refers to the maximum possible duration, achievable in Dry Mode.

To avoid water stains when using the D100, please observe the following recommendations:

1. use the correct ratio of cleaning solution: make sure you use the correct amount of cleaning solution. For the D100, the recommended ratio is 1:30 (1 liter of water and 30 milliliters of solution). The correct mixture can significantly improve the cleaning results.

2. perform slow and steady movements: Try to move the appliance steadily and evenly across the floor. This contributes to a more even cleaning and reduces the risk of streaking.

3. adjust the water level: Depending on the type of floor, water streaks may be visible. To minimize this, experiment with the water level settings to find the optimal balance for your particular floor type.

Yes, the D100 can theoretically be used on carpets, but it is not ideal. If the D100 is only used to vacuum carpets, this can easily lead to clogging of the HEPA filter and affect the suction performance. To counteract this, the D100 sprays water on the brush during the first 5 seconds in dry mode to prevent the HEPA filter from clogging.

This can cause the carpet to become slightly damp. We therefore recommend using the D100 mainly on hard floors.

Če je naprava delovala, dokler ni bila popolnoma izpraznjena in se je sama izklopila zaradi prazne baterije, sledite tem korakom:

1. D100 postavite na polnilno postajo, da začnete postopek polnjenja.
2. Po približno 10 minutah se mora zagnati funkcija samodejnega sušenja.
3. Dodatnih 60–90 minut je potrebnih, da oranžni utripajoči indikator baterije, ki na začetku prikazuje samo eno vrstico, prikaže drugo vrstico in sčasoma preklopi iz utripajoče oranžne v stalno zeleno.

Ko se naprava polni, se stanje baterije postopoma posodablja. Vrstice na zaslonu se bodo pojavile ena za drugo in označevale potek polnjenja:

- 1 bar predstavlja približno 20% napolnjenosti,
- 2 črtici pomenita približno 40 % in tako naprej, dokler ni baterija popolnoma napolnjena do 100 %.

Skupno traja približno 6 ur, da se D100 popolnoma napolni. Poskrbite, da bo naprava v tem času nemotena na polnilni postaji z aktivnim napajanjem.

Če se težava po tem, ko ste izvedli te korake, še vedno pojavlja, lahko pomeni okvaro in potrebna bo nadaljnja pomoč. Za dodatno pomoč se obrnite na podporo strankam.